The popularity of satellite TV system has made millions of people adopt it. If you want to know more about this technological wonder that has taken the entire television industry to storm, read on.

There are three basic components present in the satellite TV system. A satellite TV system of current generation utilizes an Antenna, an LNB converter and a receiver.

a) Antenna: The Satellite TV system antenna can be defined as a parabolic dish. It settles high on the property of the user that points at a particular point that is higher than the equator. The weather conditions existing in a particular area requires the use of Satellite TV system antenna of different sizes. The size of the Satellite TV antenna depends on the amount of rain or sun the area requires.

b) Satellite TV system LNB converter: Satellites require sending radio signals from the space in varied ranges of the electromagnetic spectrum. Once a beam of light hits a prism, you can find the rainbow appearing.

Similarly you can see radio signals organizing themselves in different ranges of frequencies. The frequencies of Ku-Band are very high as compared to the wave lengths. The wave lengths are comparatively smaller. The size can be compared to almost size of raindrops.

These are less useful in places where rain occur occasionally. The reason is that they have a tendency to get blocked or distorted C-band have low frequencies. Hence, these are more useful in places where rain falls frequently. Once a radio signal hits the dish, the Satellite TV antenna emphasizes this particular signal into the Satellite TV system LNB converter.

This pointer emphasizes on the middle of the dish. The converter works towards translating this signal into L-band frequency so that it can send it towards the receiver.

c) Satellite TV system receiver: This receiver is a little box that settles on the top of the television. It is responsible for interpreting the signals received from the LNB converter that sits on the top of the Satellite TV system antenna. The system utilizes the receiver just like an interpreter that tends to demodulate a preferred channel.

Any direct TV receiver has the demodulated up to four varied channels all at the same time. The process of demodulation is referred to the fact that the satellite signal cannot reach the television on its’ own. A signal that is modulated can be utilized to carry television signals. These signals are sent up to satellites and then sent down to the Direct television satellite TV.

The antenna emphasizes on the signal receiving from the satellite into the LNB. The LNB converter work towards the conversion of the signal into L-Band and the receiver in turn converts it into television signals. These televisions signals are easily understood by the television.

The satellite television can work well if the three components mentioned above are working well. Hence, it is very important that the LNB, the antenna and the receiver are working in order.