A Concrete Restoring Story

HomeHome Improvement

  • Author Jacqueline Lessor
  • Published March 11, 2011
  • Word count 594

What do you notice whenever you look at your concrete driveways, foot paths or patio? A simple grey finish with the occasional stains or dirty spot? Wouldn't it be good to have a fresh, new looking surface? Even better yet, how would you like to see a brand new looking floor without the need of having to actually clear away the previous slab and lay a brand new one? Should you reside in the United Kingdom, where there are a substantial number of garden parks, isn't it good to see a well cared for and clean slab of concrete among lush shrubs than cracked and/or crumbling cement? Concrete deep cleansing techniques and equipment can make a considerable difference in the way your footpath, or basement floor looks.

Concrete repair can really make your walkways and garage floors a lot more appealing to look at. It's easier, more convenient and less expensive then replacing the entire slab. Pressure cleansing equipment can be utilised swiftly and efficiently to completely clean up and eliminate the stains from the concrete and make it appear brand new again, then a basic concrete sealant could be used to set greater time between the subsequent desire to clean or restore it. A high-quality concrete sealant will shield against water damage, and stop irritating oil stains from sinking in as they usually do with unprotected concrete.

The Basics of Concrete Restoration

One frequent issue folks encounter regarding concrete is cracks. Cracks are generally induced by various different factors, therefore they often need repairing. As a cautionary note, prior to doing any kind of work with fixing cracked concrete, be sure to put on eye protection, in addition you'll possibly want some kind of hand protection too.

The initial step when repairing a large crack should be to get rid of the broken concrete using a hammer and chisel. Carefully chip off all of the damaged concrete wherever it is crumbling and disintegrating to the depth of around about an inch or so. Once you have done this, you'll need to "Undercut" the edges from the section which needs fixing. It's possible to do this by widening the base of the hole, but not the top, so that the inside walls are sloping inwards as they rise.

After doing the above actions, get rid of all of the debris and rubble from the surface which needs repairing and ensure that it stays moist. Permit water to soak into the gap overnight, or sprinkle some in by hand every couple of hours for around 24 hrs.

A product is required for the next phase. Mix some cement powder with water till it turns into a paste or a gel. Normally, it is three parts cement to one part water. Set this aside. Blend a bit extra cement, but make it just a little thinner this time, but remaining sufficiently thick to coat the inside edges or the walls of the crack. This phase needs to be performed as fast as you are able to whilst still executing it proficiently. The cement needs to be used before it dries.

Filling up the hole is the last step. Take the thick cement paste you mixed earlier and use it to fill the hole. Let it harden for a couple of hrs after the task is completed. Following that, cover it using plastic sheeting and sprinkle it with water several times each day for 7 days. This is actually referred to as curing the cement. There you have it, you've taken care of a crack in your concrete.

Search for Construction News along with other building information such as concrete products.

Article source: https://articlebiz.com
This article has been viewed 652 times.

Rate article

Article comments

There are no posted comments.

Related articles