Floor Heating (2 of 2)

HomeHome Improvement

  • Author John Carle
  • Published June 15, 2011
  • Word count 932

Costs

An approximate cost of an installed hydronic radiant floor heating system by a licensed mechanical contractor can range from $600 to $800 per approximately 100 square feet. This cost can be more or less depending on specific heating requirements and energy efficiency results. In addition to the heating system, a mechanical ventilation system is required in the house.

Maintenance and Repairs

It is recommended that annual maintenance be done on mechanical equipment such as the pumps, hot water heater, controls etc. If there was a problem or failure, it is commonly found in these mechanical parts. It is recommended that the installer be contacted for annual maintenance.

For repairs to the system, the homeowner should contact the installer. Be sure to have your design plan available for tubing location.

To avoid unnecessary repair work, all equipment must be used and maintained in the manner in which it was designed and installed. Homeowners disconnecting controls or moving pumps can find themselves requiring repairs and possibly voiding their warranty.

Lifespan

While the heat source in a properly maintained system can last for as long as 30 to 40 years, PEX pipes set in the floor are expected to last more than 50 years. (Some test results indicate life expectancies of 200-300 years.)

Warranty

There are two types of warranties: a Manufacturer’s Warranty and an Installation Warranty.

Most manufactures’ warranty policies are strongly dependant on certified and qualified mechanical contractors completing the installation. All require Code regulations be followed for the jurisdiction in which the home is being built. Some manufacturers also require that specific devices be field installed by the mechanical contractor to ensure full warranty coverage. There is no difference in warranty between new construction and renovations and the warranty should be given to the consumer in writing.

Installation warranty varies on the heating contractor and their warranty policies. There may be a difference in warranty between new home construction and renovations by the heating contractor.

Benefits

Comfort

Radiant floor heating provides even, comfortable, warmth as there is less air movement with this type of system. There are no drafts with this type of heating, unless it is through the building envelope. The thermal mass (concrete floor) evens out the temperature fluctuations. The floor is warm to the touch.

Energy-Efficiency

Many manufacturers claim that radiant floor heating is more economical to operate because the temperature setting may be set to 20ºC (68ºF) rather than the usual 21-22ºC (70-72ºF) as required by other types of systems. A study by CMHC (Thermostat Settings in Houses with In-Floor Heating, #01-106) has shown that people tend to keep their thermostats set the same as if they had a forced air system. Even so, the warmest air is at the floor where it is desired (and not at the ceiling) and there is reduced heat loss through the ceiling and walls.

Zoning a variety of rooms with the options for different temperatures has the potential to reduce energy consumption.

Energy Source Compatibility

Since radiant floor heating has a low operating temperature, a wide range of sources can be used to heat the water–a ground-source heat pump, a condensing or non-condensing boiler, solar or even district heating.

Quietness

The system is quiet because a properly-sized circulator pump, used to slowly move the water, is almost inaudible. The loudest sound in the system is usually the gas or oil burner.

Cleanliness

Unlike conventional forced-air furnaces, radiant floor heating has no ducts or radiators to contribute to dust collection or movement. Note: duct work is required for the mechanical ventilation system or air conditioning.

For residents with allergies, the reduction in dust movement may be beneficial.

Room Function

Hydronic radiant floor heating is virtually an invisible system. Without baseboard heaters, forced air registers etc, furniture layout is not restricted by the heating system. Bathrooms or special use areas with hard floor finishes are well suited to this type of heating.

Cautions and Solutions

Due to thermal mass, the system may be slower to respond to temperature changes. Overheating can occur in poorly controlled or zoned systems. The system is not designed to have the temperature frequently adjusted.

Night setbacks are not practical in most situations as the system is slow to react.

Ventilation must be done separately. As air conditioning cannot be used in ventilation-sized ducts, window/wall air conditioning can be installed or room-by-room split systems can be used. Additionally, high-velocity air conditioning systems that use small outlets in ceiling or walls have proven very compatible with radiant floor heating operation.

Extra support may be needed for the weight of thermal mass topping on a wood floor. If the building structure can’t support the weight, then the dry plate system can be considered.

This is not a do-it-yourself project. It requires professional installation, maintenance and repair. Having professionals do the installation will allow you to have the best performance and warranty on the heating system.

More Information

Heating contractors, heating equipment wholesalers and heating associations (for example, Canadian Hydronics Council and the Hydronic Marketing Group) can provide specific information on hydronic radiant heat products. The Yellow PagesTM or Internet, provides a variety of sources.

Although this information product reflects housing experts' current knowledge, it is provided for general information purposes only. Any reliance or action taken based on the information, materials and techniques described are the responsibility of the user. Readers are advised to consult appropriate professional resources to determine what is safe and suitable in their particular case. CMHC assumes no responsibility for any consequence arising from use of the information, materials and techniques described.

http://www.knock-knock.ca

John Carle

RE/MAX Real Estate Edmonton

102 12650 151 Ave

Edmonton, AB T5X 0A1

John@Knock-Knock.ca

http://www.knock-knock.ca

780-937-7534 / 780-701-9090

Article source: https://articlebiz.com
This article has been viewed 804 times.

Rate article

Article comments

There are no posted comments.

Related articles