As I said earlier, try the above methods in sequence, one-at-a-time, checking each time to see if your latest change has done the trick for you.

What happens if it still won’t fit?

Now, if you’ve used all of the above tricks and you still can’t get the letter to fit onto one page, it’s time to admit that you’ve got a real two-pager. In which case, you should then think about “reversing” some of the compression tricks that you applied when you tried to “squeeze” the letter, and then concentrate on making a balanced looking second page.

There’s nothing worse looking than a letter with a one or two sentence second page! So in this case, you may want to actually “stretch” the letter out a bit.

Often, at this stage I actually increase the line spacing and reduce the margins slightly so that there will be a decent sized overflow onto the second page.

For example, try reversing steps 1, 2 and 4 above. So instead of decreasing the top, bottom and side margins on page one, try increasing them by 1/4 in. all around. Then increase the point size and see if that helps. Ideally, try to get the page to break cleanly at a paragraph break, for a nice tidy page-to-page transition.

Again, I have used these little “compression” tricks thousands of times, and nobody has ever pulled out their ruler and chastised me for inaccuracy.

The important thing is to end up with a professional "looking" letter.

In fact, if you do a very detailed check of the real-life templates included in any one of my Writing Toolkits you would find that I have used one or more of the above tricks on many of them. But, I’m not telling which ones!

Page 2 of 2 :: First | Last :: Prev | 1 2 | Next