o Lower the bottom idle bar.

o Unroll 2ft of film and push the idler bar back into place and drape film over the bottom roll of film. Place the bottom roll of film back into the round hole of the right side frame and the left side into the hex shaped brake hub.

o Remove the top film supply roll from the laminator and repeat steps 6 and 7 from above. Ensure that when you install the film onto the roller that the film will unroll from the bottom after the film supply is loaded back on the laminator.

o Unroll 2ft of film and drape the film over the top idler bar and completely over both heat rollers

o Slide the feed tray under the bottom film web that is draped over the bottom roll of film. Reinstall the feed table so that the bottom film is resting on the tray.

o Slide the threading card between the feed tray and the laminating film that is laying on the tray. Gently push the threading card into the nip area of the heat rollers. The card should now be guiding both rolls of film into the heat rollers

o Lower the safety shield and press the RUN button on the laminator. Watch the leading edge of the threading card to ensure that it enters the nip area of the heat rollers and is being pulled into the laminator. Push STOP once the threading card has exited the rear of the laminator.

Page 2 of 2 :: First | Last :: Prev | 1 2 | Next