But there are cases when sites place important messages, via flash, in these locations. But if many people tune out these locations, they are also tuning out that important message. Hence the reason the flash doesn’t do so well on the page.

So there’s tip number one: Don’t place your flash where it will be ignored – namely those spots on the page normally associated with advertising.

My second flash tip – don’ t take up most of the screen with it. Keep the screen real estate it occupies to less than ½ the screen, preferably on the left side. There are many reasons for this:

Too often, as people are orienting themselves to the page, their eyes scan the page and are all over it for a few seconds, and then fixate on the top left of the page. If you have a flash movie running (and especially if its one without controls) they have missed a few seconds of that message. And we all know what good a message is that’s incomplete?

Another reason for minimizing flash usage: While more and more people are adopting broadband every day, still close to half of the US uses dial up. Which means everything takes longer to load. And if these users are waiting for a flash movie to load, they could navigate away from your site in frustration because the page is taking so long to load.

Some other recommendations:

Don’t use the flash to tell the story, use it to enhance the story. If you are trying to sell a product, leave the important information in the HTML of the page, but use the flash to emphasize the product by either displaying it, or pointing out the benefits. your flash should be complementary and not too overwhelming.

Finally, did you know you can also externalize the code required to display the flash? This is something that can help improve page load times which could improve spiderability.

Using a technique similar to one I described in the externalizing JavaScript article, you can externalize the code used to render the flash. You can use the same code used to create a drop down box via JavaScript to externalize the flash code (using the document.write code and embedding the HTML needed to display the flash there).

As you can see, based on this article, is that flash isn’t all that bad, provided its used properly. That means it shouldn’t be too overpowering or occupy too much of the page. It should be complementary to the message the page is intending to give, and should be located in places that people will look at, and not in places normally associated with advertising.

If you follow these simple rules, your flash can become an essential selling point to your site. One which could provide your customers the little push they need to move from browsers to buyers.

Page 2 of 2 :: First | Last :: Prev | 1 2 | Next