ArticleBiz.com :: Free article content
Authors: Maximum article exposure. Publishers: Reprintable article content.  
BROWSE ARTICLES
ArticleBiz.com Home
Featured Articles
Recently Added Articles
Most Viewed Articles
Article Comments
Advanced Article Search
AUTHORS
Submit Article
Check Article Status
Author TOS
PUBLISHERS
RSS Article Feeds
Terms of Service

Data Recovery over Hard disk failure
Home :: Computers & Technology :: Technology
By: Muneer Mohammad Email Article
Word Count: 1138 Digg it | Del.icio.us it | Google it | StumbleUpon it

  

Hard Disk: An Introduction
--------------------------
Hard Disks are used to store information. All information on computers are stored in files. Hard disks store the majority of information on today's modern computer. Hard disk drives (HDDs) can be critically damaged by static electricity, shock, and other factors, often resulting in failure or the loss of valuable data. In many cases it may become necessary to recover information from your hard drive. Such retrieval is quite possible.

Hard Disk Failure
-----------------
*Physical Failures
Physical failure occurs from sudden switch off, power failure, sliding them off desks and cheap components. As for data loss, data is only magnetic impulses on the surface of a hard disk. And ridiculously small bits of magnetism at that! When the magnetic impulse fades, or changes position, trouble starts.

Drive Alignment Drift is another cause of problems. Mechanical devices are subject to wear and tear, heat and cold, loosening tolerances etc.

The small changes in the read/write heads wouldn't matter usually, as data still gets written in the same place as it will be read later. However, there is some data that hardly ever gets re-written, and that is the Sector ID Headers.

*Logical Failures
Master Boot Record Failure
Technically, when the Master Boot Record is working correctly, the master boot code scans the partition table for the active partition, finds the starting sector, loads a copy of the boot sector from the active partition into memory and then transfers control to the executable code in the boot sector. If the master boot code cannot complete these functions, the system displays a message similar to the MBR error.
*Boot Sector Failure
The boot sector is a region of a hard disk, floppy disk, and other similar data storage device. It is loaded to memory and executed as a part of the bootstrap sequence. The boot sector contains a small computer program that is loaded on the operating system into memory and transfers the control.

Most boot sector failure occurs by the defection of boot sector virus. Boot sector viruses are usually spread by infected floppy disks. In the past, these were usually bootable disks, but this is no longer the case. A floppy disk does not need to be bootable to transmit a boot virus. Any disk can cause infection if it is in the drive when the computer boots up or shuts down.

*Accidentally Deleted Data
Some time some how you may delete a file thinking we don?t need it any more, but in a week or or two you may realize that it is a needed one. It happens to the best of us, but fortunately there are ways to get these lost files back.

When it comes to data on your computer, it is almost impossible to accidentally remove it beyond recoverability. Even if you are intentionally trying to completely wipe a file from your hard drive it is exceedingly difficult.

Page 1 of 2 :: First | Last :: Prev | 1 2 | Next

Muneer Mohammad Admin http://www.PC4Safe.com

Article Source: http://www.ArticleBiz.com

This article has been viewed 205 times.

Rate Article
Rating: 5 / 5 stars - 1 vote(s).

Article Comments
There are no comments for this article.

Leave A Reply
 Your Name
 Your Email Address [will not be published]
 Your Website [optional]
 What is two + eight? [tell us you're human]
Notify me of followup comments via email


Related Articles


Copyright © 2009 by ArticleBiz.com. All rights reserved.

Terms of Service | Privacy Policy | Contact Us | Submit Article | Editorial